Mitsubishi 2015 OUTLANDER, Owner'S Manual

Page: 172 / 490

NOTE
l If the lamp flashes unusually quickly, the
bulb in a turn-signal lamp may have burned
out. We recommend you to have the vehicle
inspected.
l It is possible to activate the following func-
tions.
• Flashing of the turn-signal lamps when
the lever is operated with the ignition
switch or the operation mode is in ACC.
• Deactivate the turn-signal lamp 3-flash
function for lane changes
• The time required to operate the lever for
the 3-flash function can be adjusted.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
l It is possible to change the tone of a sound-
ing buzzer as the turn-signal lamps flash.
[Vehicle equipped with the multi informa-
tion display - type 1]
Refer to “Changing the turn-signal sound”
on page 5-19.
[Vehicle equipped with the multi informa-
tion display - type 2]
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Hazard warning flasher
switch
E00506601001
Use the hazard warning flasher switch when
the vehicle has to be parked on the road for
any emergency.
The hazard warning flashers can always be
operated, regardless of the ignition switch po-
sition or the operation mode.
Push the switch to turn on the hazard warning
flashers, all turn-signal lamps flash continu-
ously. To turn them off, push the switch
again.
NOTE
l On vehicles equipped with the emergency
stop signal system, while the hazard warning
lamps are blinking due to having manually
pushed the switch, the emergency stop sig-
nal system does not operate.
Refer to “Emergency stop signal system*”
on page 6-63.
ECO mode switch*
E00531801052
ECO mode is an eco-driving support system
which automatically controls the engine, air
conditioning system and 4WD system (4WD
vehicles only) and S-AWC (if so equipped)
to improve fuel efficiency.
Refer to “Electronically controlled 4WD sys-
tem” on page 6-51.
Refer to “S-AWC (Super-All Wheel Con-
trol)” on page 6-53
Refer to “Automatic climate control air con-
ditioner” on page 7-04.
The ECO mode starts working by pressing
the ECO mode switch when the ignition
switch or the power mode is set to “ON”.
Push the switch again and the ECO mode
will cancel.
Hazard warning flasher switch
5-62
OGFE16E1
Instruments and controls
5