Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 218 / 250

NOTE
l If you are unsure of how to carry out the
work as required, we recommend you to con-
sult a specialist.
l Be careful not to scratch the vehicle body
when removing a lamp or lens.
l When it rains or when the vehicle has been
washed, the inside of the lens sometimes be-
comes foggy. This is the same phenomenon
as when window glass mists up on a humid
day, and does not indicate a functional prob-
lem. When the lamp is switched on, the heat
will remove the fog. However, if water gath-
ers inside the lamp, we recommend you to
have the lamp checked.
Bulb location and capacity
E01003200320
When replacing a bulb, use a new bulb with the
same wattage and colour.
Outside
E01003303032
Front
1- Front turn-signal lamps: 21 W (PY21W)
2- Headlamps: 60/55 W (H4)
3- Position lamps: 5 W (W5W)
4- Type 1
Daytime running lamps: 13 W (P13W)
Type 2
Front fog lamps: 35 W (H8)
Daytime running lamps: 13 W (P13W)
5- Side turn-signal lamps: 5 W
Codes in parentheses indicate bulb types.
NOTE
l For the side turn-signal lamp, it is not possi-
ble to repair or replace just the bulb.
For repair and replacement, contact a
MITSUBISHI MOTORS Authorized Service
Point.
Rear
6- High-mounted stop lamp (bulb type)*: 5 W
(W5W)
7- Licence plate lamps: 5 W (W5W)
8- Reversing lamps (passenger’s side): 21 W
(P21W)
Rear fog lamp (driver’s side): 21 W (P21W)
9- Rear turn-signal lamps: 21 W (P21W)
10- Stop and tail lamps: 21/5 W (P21/5W)
Codes in parentheses indicate bulb types.
NOTE
l On a vehicle with a rear spoiler, the high-
mounted stop lamp uses LEDs rather than
bulbs. For repair and replacement, contact a
MITSUBISHI MOTORS Authorized Service
Point.
Maintenance
8-20
OA0X13E4
8