— 23 —
3
When two or more IUs are connected to one R/C, an IU list is
displayed. Tap the IU No. to be set.
The IU select screen shows up to 8 units. When 9 or more units
are connected, the 9th and later units are displayed by tapping the
Next
button.
4
Select the No. of air outlet of which the flap motion range is changed.
■
When there are two or more air outlets such as the
FDT type and the air outlet to be set cannot be
identified, set the upper and lower limit positions of
any flap provisionally. When the setting is confirmed,
the flap at the set air outlet moves once to the lower
limit position so that the air outlet position can be
identified. After checking the air outlet position in
this way, select the air outlet No. to be set.
2
When the Input password screen is displayed, enter the
administrator password.
■
There are cases that the Input password screen is displayed when the Permission/
Prohibition setting is “Prohibition”
(
☞
page 42).
Tap the
Set
button after entering the administrator password
(4-digit number).
When the password is unknown or wrong, the setting cannot be
changed.
When only one IU is connected to one R/C, go to the step
4
.
When two or more IUs are connected to one R/C, go to the step
3
.
· For the administrator password at the factory setting, refer to the Installation
Manual (consult your dealer).
· When your administrator password is forgotten, initialize the password by referring
to the Installation Manual (consult your deaker).
Note
No.4
No.2
No.1
No.3
Pipe side
Drain hose side
Drain hose side
Control box
Air outlet No.
[In case of FDT]
