–
–
'14 • KX-SM-202
(2) Compressor control (Master unit/slave unit)
(a) Starting compressor
(i) Compressor starting order
After turning the power on, firstly CM1 compressor starts. (In case of the combination use, it is CM01 of master unit)
And corresponding to the condition of under-dome temperature and to the required capacity of indoor units thermo-
stat ON, the next compressor will start sequentially, and finally maximum 6 compressors ( in case of 3 outdoor units
combination use) will start simultaneously.
1) Single use (Model 280, 335)
CM1
Range of the compressor operation speed relative to load is as follows.
System load range
(Number of operating outdoor units)
0
1
Local load range
(Number of compressors operating in outdoor units)
0
1
CM
0rps
20−140rps
＊
Note()
＊
only model is MAX 0rps, model 0 is MAX 0rps.
2) Single use (Model 400, 450)
CM1
Range of the compressor operation frequency relative to load is as follows.
System load range
0
1
Local load range
0
1
CM
0rps
20−120rps
3) Single use (Model 475, 500, 560 : 2 compressors specification)
CM1 CM2
Range of the compressor operation frequency relative to load is as follows.
System load range
0
1
Local load range
0
1
2
CM
0rps
20−112rps
31−120rps
CM
0rps
0rps
31−120rps
4) 2 outdoor units combination use (Model 615, 670)
Master unit Slave unit
CM01
CM11
(CM1)
(CM1)
Range of the compressor operation frequency relative to load is as follows. Following table is applicable when CM0 starts initially.
System load range
0
1
1
Local load range
0
1
1
Master unit
CM0
0rps
20−112rps
31−120rps
Slave unit
CM
0rps
0rps
31−120rps