EN-6
Preparing your projector
1
Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in
the package.
Cables
Remote control parts
Remote control
(290P188-10)
RS-232C cable
(J2552-0114-00)
R6 (size-AA)
battery (two)
Computer cable
(J2552-0072-05)
Others
• Lens cap (attached to the projector)
• Lens ring
• Terminal cover
• Lamp replacement tray
• CD-ROM
• Safety Manual/Quick Start up
Mini D-SUB
15-pin
Mini D-SUB
15-pin
D-SUB
9-pin
Power supply part
• Used for projector control
by computer.
D-SUB
9-pin
Power cord for US (J2552-0063-00)
Power cord for EU/South Korea (J2552-0066-00)
Power cord for UK (J2552-0065-00)
Power cord for Australia (02552-0306-00)
Inserting the batteries into the remote control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
• If the battery is inserted from the (+) side first, inserting
the (-) side is difficult because the coil spring end hits
on the battery side. If the battery is forced to insert in
this way, the outer label of the battery may get ripped
and it may cause a short-circuit and heating.
3. Attach the rear lid.
Important:
• Use two size-AA batteries (R6).
• Replace the 2 batteries with new ones when the remote
control is slow to operate.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the
batteries.
Caution:
• Use of a battery of wrong type may cause explosion.
• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
• Dispose of used batteries according to your local regulations.
• Before you dispose of the batteries, insulate them by placing insulation tape on the positive (+) and negative (-)
terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may short
out, resulting in fire or explosion.
•
Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or water.
• Be sure to handle the batteries according to the instructions.
• Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
• Keep batteries out of reach of children and pets. If children swallow the battery, see a doctor immediately.
• Remove the batteries, if the remote control is not used for a long time.
• Do not combine a new battery with an old one.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact
with your eyes, rinse them with water and then consult your doctor.
• Do not carry or store the batteries together with metallic ballpoint pens, necklaces, coins, or hairpins. Otherwise, they
may short out, causing explosion or liquid leakage and resulting in fire or injury.
• Do not store the batteries where they are exposed to direct sunlight or subjected to high temperature and high humidity.
High temperature and high humidity may cause corrosion or liquid leakage.
3
2
Important:
• The attached power cord is to be used exclusively for this product. Never use it for other products.
