EN-18
AUDIO OUT
2
1
2
1
Viewing computer images
2
1
A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the computer cable that is connected to the
monitor.
For analog connection:
(For using the COMPUTER/COMPONENT/VIDEO IN 1
terminal.)
1. Connect one end of the supplied computer cable to the
COMPUTER/COMPONENT/VIDEO IN 1 terminal of the
projector.
2. Connect the other end of the computer cable to the
monitor port of the computer.
• When viewing images supplied from an analog-connected
computer, press the COMPUTER 1 button on the remote
control.
For analog connection:
(For using the COMPUTER/COMPONENT/VIDEO IN 2
terminal.)
1. Connect one end of a commercially available BNC cable to
the COMPUTER/COMPONENT/VIDEO IN 2 terminal of the
projector.
2. Connect the other end of the BNC cable to the 5 BNC
terminals of the monitor port of the computer.
• When viewing images supplied from an analog-connected
computer, press the COMPUTER 2 button on the remote
control.
For digital connection:
1. Connect one end of a commercially available DVI cable to
the COMPUTER/COMPONENT/VIDEO DVI-D IN (HDCP)
terminal of the projector.
2. Connect the other end of the DVI cable to the DVI terminal
of the computer.
• When viewing images supplied from a digital-connected
computer, press the DVI-D (HDCP) button on the remote
control.
•
Turn on the power of the projector before starting the
computer.
For audio connection:
1. Connect one end of a commercially available PC audio
cable to the AUDIO IN 1/2 terminal of the projector.
2. Connect the other end of the PC audio cable to the audio
output terminal of the computer.
• This projector uses stereo pin jack for its audio input. Check
the type of the audio output terminal of the connected
computer and prepare a proper cable for connection. Some
computers don’t have the audio output terminal.
• Speaker output is mono.
• Only when STADNBY MODE is set to STANDARD, audio
is output from the AUDIO OUT terminal during power
standby.
COMPUTER/
COMPONENT/
VIDEO IN 1
COMPUTER/
COMPONENT/
VIDEO DVI-D IN
(HDCP)
To monitor port
Computer cable
DVI cable (option)
To DVI
2
1
R/P
R
G/Y B/P
B
H/HV V
V H/HV B/P
B
G/Y R/P
R
COMPUTER/
COMPONENT/
VIDEO IN 2
• Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected images.
• Images may not be projected correctly, depending on the type of the connected computer.
• When DVI-D signal is input, some signal setting menus are unavailable.
• Also read the instruction manual of the equipment to be connected.
• Contact your dealer for details of connection.
To monitor
port (5 BNC)
Computer
Computer
To audio output
terminal
AUDIO IN 1/2
Computer
Computer
BNC cable (option)
PC audio cable
(option)
