Mitsubishi Electric XD400U, User Manual

Page: 20 / 34

EN - 20
Adjustment of the image from the computer
This projector adjusts the format of the video signal
supplied from the computer. However, sometimes im-
ages are not projected correctly owing to the type of
the computer used. When the image from the computer
isn ' t projected correctly, press the AUTO POSITION
button. (See page 15.) If the image isn ' t projected cor-
rectly yet, adjust the image from the computer using the
menu.
To move the image horizontally :
Adjust HORIZ. POSITION in the SIGNAL menu. Press
the  button to move the image to the left. Press the 
button to move the image to the right.
To move the image vertically :
Adjust VERT. POSITION in the SIGNAL menu. Press
the  button to move the image upward. Press the 
button to move the image downward.
When the image flickers or the image is out of focus :
Adjust FINE SYNC. in the SIGNAL menu.
When the top part of the image flags :
Change the setting of HOLD in the SIGNAL menu. Se-
lect ON , press the ENTER button, and adjust BEGIN
or END to minimize the flagging.
When wide strips appear :
Adjust CLAMP POSITION or CLAMP WIDTH in the SIG-
NAL - USER menu.
When the motion doesn't run smoothly :
Adjust VERT. SYNC. in the SIGNAL - USER menu. Se-
lect AUTO for normal use.
When noise appears on the right or left half of the
image :
Adjust SHUTTER (LS) or SHUTTER (RS) in the SIGNAL
- USER menu.
When noise appears on the top or bottom part of the
image :
Adjust SHUTTER (U) or SHUTTER (L) in the SIGNAL -
USER menu.
R G B
R G B
SIGNAL
HORIZ. POSITION 0
VERT. POSITION 0
TRACKING 0
COMPUTER
INPUT
RGB
FINE SYNC. 0
USER
XGA60
opt.
OK
ON HOLD
CLAMP
POSITION
SIGNAL-USER
0
CLAMP WIDTH 1
SHUTTER (U) 0
SHUTTER (L) 0
SHUTTER (LS) 0
SHUTTER (RS) 0
VERT. SYNC. AUTO
?
Important:
Do not change any of the settings in the SIGNAL-USER
menu for normal use.
Simple adjustment method
1. Select HORIZ. POSITION in the SIGNAL menu.
2. Press the
 or  button to adjust the horizontal start
position (or the left side of the image).
3. Select TRACKING in the SIGNAL menu.
4. Press the
 or  button to adjust the horizontal end
position (or the right edge of the image).
5. Repeat steps 1 to 4 for optimum adjustment results.
6. Select VERT. POSITION in the SIGNAL menu.
7. Press the
 or  button to adjust the vertical start
position (or the upper edge of the image).
Image adjustment (continued)