4
How to use the unit
Introduction
Open the power controll section cover.
Turn on the power switch.
3.Close the power controll section cover.
Power controll section
Display
Power
switch
Heater
switch
Cover
Air
speed
knob
Power lamp
With the heater switch ON
Check lamp
Heater lamp
Power
Check
Heater
Power
Check
Heater
Power lamp
With the heater switch OFF
Check lamp
Heater lamp
In case of trouble or error
Power
Check
Heater
Power lamp
With the power switch OFF
Check lamp
Heater lamp
Power lamp
Check lamp
Heater lamp
Power
Check
Heater
Check lamp
When a malfunction or error occurs, the check lamp on the right side of the display will
either light up or flash. Turn the power switch off, wait approximately 40 seconds until the
all the lamps in the display go off, and then turn the power back on. If the check lamp is
still on or flashing, turn off the power, shut off the ground-fault circuit interrupter, and
contact your dealer.
When not using the unit for long periods of time
(With the heater switch “OFF”)
* When the heater switch is turned “ON”, approx. 1,100 W of power is
consumed to accumulate heat by operating the heater.
Turn the power switch off.
The unit consumes approximately 2W of power even if unused when the power is on.
With both hands open, insert them
all the way in
.
The unit will come on automatically.
Pull them out slowly,
letting the air blow the
water off.
Pull hands all the way
out.
Repeat until dry
Insert from each side.
Bring upwards slowly.
Pull out.
Information
As the hand dryer is open at both sides
of the main unit, your hands may also be
inserted from the sides. If your hands are
inserted from the sides and pulled
upwards a few times, you can dry your
hands without any risk of water drops
blowing upwards.
How to dry your hands
1.
2.
Note:
Power lamp and heater lamp turn on. (Display)
Emblem lamp turns on.
Illumination lamp turns on.
Adjust the Air speed knob to the best point.
When the power switch is turned on, make sure to remove
hands from the hand-drying area. Take sufficient care to
avoid this because it may deteriorate the sensitivity of sensor.
-
+
OFF
ON
OFF
ON
Power
Air speed
Heater
1
2
3
2
1
3
Check lamp
Power lamp
Display
Emblem
Heater lamp
Maint
Drain tan
JT-SB116EH-W-CA-IB_874HD6901-GB 06.12.9 2:12 PM ページ 5
