– 12 –
ON-TIMER operation
1
2
How to cancel
Press the CANCEL button to turn off the timer
indicator.
Example: In the case the preferred room temperature is required at 8:00.
Press the ON-TIMER button.
ON TIMER indicator
is blinking.
3
■
Operation starts 5 to 60 minutes before the set time so that the room temperature reaches the optimum temperature at the set time.
Page 13
ON-TIMER operation can be set regardless of whether the air-conditioner is running or not.
SLEEP TIMER + ON-TIMER operation
■
Combined timer operation of SLEEP TIMER and ON TIMER.
Example: When it is required to stop after 3 hours and then start operation at 8:00, near
the set temperature.
■
SLEEP TIMER setting
Set by the procedures on page 11.
Set to
■
ON TIMER operation setting
Set by the above procedure mentioned in ON TIMER.
Set to
The setting of the lighting of the timer light (yellow) of this unit is complete.
h
•
After the SLEEP TIMER set time has elapsed, the operation stops, and it starts
from 5 to 60 minutes before the ON TIMER’s set time.
•
The timer light is turned off when ON TIMER set time comes.
Changing of set time
Set a new time by using the SLEEP or ON TIMER button.
How to cancel
Press the CANCEL button to turn off the timer display.
Press the “
or
” button.
Every time the
button is pressed, the display is switched in the order of:
0:00
0:10
0:20
...
(Units of ten minutes)
1:00
1:10
Every time the
button is pressed, the display is switched in the order of:
0:00
23:50
23:40
...
(Units of ten minutes)
23:00
22:50
Set at 8:00.
Press the ON TIMER button.
The display changes from blinking to steady lighting and the setting is complete.
The timer light (yellow) is on.
The operation stops if it is set during operation.
Changing of set time
Set a new time by using the ON-TIMER button.
•
Operation starts 5 to 60 minutes before the set time.
•
The timer light (yellow) goes out at the set time.
•
Make sure to press the button within 60 seconds from the last operation in step 2, other-
wise the setting is not completed.
•
The current time is not displayed during ON-TIMER operation.
NOTE
RKX012A316_EN_001-020
12/21/2009, 10:41
12
