Mitsubishi Electric SRF25ZIX-S, User Manual

Page: 11 / 122

– 10 –
Airflow direction adjustment
Adjusting airflow direction
■
Up/down direction can be adjusted with the AIRFLOW button on the remote control. Every time you press this button the mode changes as
follows:
Change on AIRFLOW (UP/DOWN) mode.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at the posi-
tion. Since this angle is memorized in the microcomputer, the flap will automatically be set at this angle
when the next operation is started.
DANGER
•
Do not expose directory to airflow from the air-conditioner for a long time.
CAUTION
• When in COOL or DRY operation, do not operate for a long period with the
airflow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
•
Do not try to adjust the flaps by hand, as the control angle may change or the flap
may not be closed completely.
HEAT
(Slant forward
blowing)
(Horizontal
blowing)
COOL, DRY
•
Recommended angle of the flap when stopping
•
When operation starts, the flap direction is fixed at the vertical position in order to avoid cold draft, and return to the set the position that was set after the warm air
supply is starting.
•
The flap direction will be controlled to the vertical position when the room temperature reaches the set temperature and compressor stops or when defrosting is in
operation.
• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is supplied and the flap goes to the
set position.
(Swing)
(Flap stopped)
NOTE FOR HEATING OPERATION
CAUTION
•
When adjusting the air flow direction, be careful with the fans
rotating in the air conditioner.
Otherwise you may injure your fingers.
•
The lower flap is not adjustable while the air conditioner is
OFF.
Adjusting left/right air flow direction
Adjust the direction by moving the left/right air
flow fin by hand.
RFB012A001_EN_001_024 11/13/2008, 12:45 10