Mitsubishi Electric PUMY-P112, Installation Manual

Page: 19 / 44

7HVWUXQ
8VLQJUHPRWHFRQWUROOHU
Refer to the indoor unit installation manual.
‡ %HVXUHWRSHUIRUPWKHWHVWUXQIRUHDFKLQGRRUXQLW0DNHVXUHHDFKLQGRRU
unit operates properly following the installation manual attached to the unit.
‡ ,I\RXSHUIRUPWKHWHVWUXQIRUDOOLQGRRUXQLWVDWRQFH\RXFDQQRWGHWHFWDQ\
erroneous connection, if any, of the refrigerant pipes and the connecting wires.
* The compressor operation is not available for 3 minutes at least after the power
is supplied.
‡ 7KHFRPSUHVVRUFDQHPLWQRLVHMXVWDIWHUWXUQRQWKHSRZHUVXSSO\RULQFDVH
of low outside air temperature.
5HIULJHUDQWFROOHFWLQJ3XPSGRZQ
Perform the following procedures to collect the refrigerant when moving the indoor
unit or the outdoor unit.
1
Turn off the circuit breaker.
2
Connect the low pressure side of the gauge manifold to the service port of the
gas side stop valve.
3 Close the liquid stop valve.
4
Supply power (circuit breaker).
* Start-up of the indoor-outdoor communication takes about 3 minutes after the
power (circuit breaker) is turned on. Start the pump-down operation 3 to 4 minutes
DIWHUWKHSRZHUFLUFXLWEUHDNHULVWXUQHG21
5
&RQ¿UPWKDW6:LVVHWWR2))DQGWKHQVHW6:WR21WRSHUIRUPWKHWHVW
run for cooling operation. The compressor (outdoor unit) and ventilators (indoor
and outdoor units) start operating and test run for cooling operation begins.
Immediately after performing the test run for cooling operation, set the outdoor
VHUYLFHVZLWFK6:SXPSGRZQVZLWFKIURP2))WR21
'RQRWFRQWLQXHWRRSHUDWHIRUDORQJWLPHZLWKWKHVZLWFK6:VHWWR210DNH
sure to switch it to OFF after pump down is completed.
6
Fully close the gas stop valve when the pressure reading on the gauge drops
03DDSSUR[LPDWHO\NJIFP
2
)
7 Stop the air conditioner operation (SW3-1: OFF). Set the outdoor service switch
6:IURP21WR2))
8
Turn off the power supply (circuit breaker).
* If too much refrigerant has been added to the air conditioner system, the pres-
VXUHPD\QRWGURSWR03DNJIFP 2 ). If this occurs, use a refrigerant
collecting device to collect all of the refrigerant in the system, and then recharge
the system with the correct amount of refrigerant after the indoor and outdoor
units have been relocated.
:DUQLQJ
:KHQSXPSLQJGRZQWKHUHIULJHUDQWVWRSWKHFRPSUHVVRUEHIRUHGLVFRQQHFW -
LQJWKHUHIULJHUDQWSLSHV7KHFRPSUHVVRUPD\EXUVWDQGFDXVHLQMXU\LIDQ\
IRUHLJQVXEVWDQFHVXFKDVDLUHQWHUVWKHV\VWHP
%HIRUHWHVWUXQ
Ź $IWHUFRPSOHWLQJLQVWDOODWLRQDQGWKHZLULQJDQGSLSLQJRIWKHLQGRRUDQG
RXWGRRUXQLWVFKHFNIRUUHIULJHUDQWOHDNDJHORRVHQHVVLQWKHSRZHUVXSSO\
RUFRQWUROZLULQJZURQJSRODULW\DQGQRGLVFRQQHFWLRQRIRQHSKDVHLQWKH
VXSSO\
Ź 8VHDYROW0RKPWHVWHUWRFKHFNWKDWWKHUHVLVWDQFHEHWZHHQWKHSRZHU
VXSSO\WHUPLQDOVDQGJURXQGLVDWOHDVW0Ÿ
Ź 'RQRWFDUU\RXWWKLVWHVWRQWKHFRQWUROZLULQJORZYROWDJHFLUFXLWWHUPLQDOV
:DUQLQJ
'RQRWXVHWKHDLUFRQGLWLRQHULIWKHLQVXODWLRQUHVLVWDQFHLVOHVVWKDQ0Ÿ
Insulation resistance
After installation or after the power source to the unit has been cut for an extended
SHULRGWKHLQVXODWLRQUHVLVWDQFHZLOOGURSEHORZ0ŸGXHWRUHIULJHUDQWDFFXPXODW -
ing in the compressor. This is not a malfunction. Perform the following procedures.
1. Remove the wires from the compressor and measure the insulation resistance of
the compressor.
,IWKHLQVXODWLRQUHVLVWDQFHLVEHORZ0ŸWKHFRPSUHVVRULVIDXOW\RUWKHUHVLVWDQFH
dropped due the accumulation of refrigerant in the compressor.
3. After connecting the wires to the compressor, the compressor will start to warm
up after power is supplied. After supplying power for the times indicated below,
measure the insulation resistance again.
‡ 7KHLQVXODWLRQUHVLVWDQFHGURSVGXHWRDFFXPXODWLRQRIUHIULJHUDQWLQWKHFRP -
SUHVVRU7KHUHVLVWDQFHZLOOULVHDERYH0ŸDIWHUWKHFRPSUHVVRULVZDUPHG
up for 12 hours.
(The time necessary to warm up the compressor varies according to atmospheric
conditions and refrigerant accumulation.)
‡ 7RRSHUDWHWKHFRPSUHVVRUZLWKUHIULJHUDQWDFFXPXODWHGLQWKHFRPSUHVVRUWKH
compressor must be warmed up at least 12 hours to prevent breakdown.
,IWKHLQVXODWLRQUHVLVWDQFHULVHVDERYH0ŸWKHFRPSUHVVRULVQRWIDXOW\
&DXWLRQ
‡ 7KHFRPSUHVVRUZLOOQRWRSHUDWHXQOHVVWKHSRZHUVXSSO\SKDVHFRQQHFWLRQ
LVFRUUHFW
‡ 7XUQRQWKHSRZHUDWOHDVWKRXUVEHIRUHVWDUWLQJRSHUDWLRQ
- Starting operation immediately after turning on the main power switch can result
in severe damage to internal parts. Keep the power switch turned on during the
operational season.
Ź 7KHIROORZLQJVPXVWEHFKHFNHGDVZHOO
‡ 7KHRXWGRRUXQLWLVQRWIDXOW\/('RQWKHFRQWUROERDUGRIWKHRXWGRRUXQLWÀDVK
when the outdoor unit is faulty.
‡ %RWKWKHJDVDQGOLTXLGVWRSYDOYHVDUHFRPSOHWHO\RSHQ
7HVWUXQ
$ERXWWKHUHVWDUWSURWHFWLYHPHFKDQLVP
Once the compressor stops, the restart preventive device operates so the compressor
will not operate for 3 minutes to protect the air conditioner.