79
Compressor
(MC)
Valve bed
Separator
Separator
fixing screw
Power
receiver
Valve
bed fixing
screws
Compressor
fixing nut
13. Removing the compressor (MC)
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3)
Remove 2 front cover panel fixing screws (5 × 12) and
remove the front cover panel. (See Photo 3-1)
(4)
Remove 2 back cover panel fixing screws (5 × 12) and
remove the back cover panel.
(5) Remove the electrical parts box. (See Photo 3)
(6)
Remove 3 valve bed fixing screws (4 × 10) and 4 ball valve
and stop valve fixing screws (5 × 16) and then remove the
valve bed.
(7)
Remove 3 right side panel fixing screws (5 × 12) in the
rear of the unit and then remove the right side panel.
(8)
Remove 3 separator fixing screws (4 × 10) and remove the
separator.
(9) Recover refrigerant.
(10)
Remove the 3 points of the compressor fixing nut using a
spanner or a adjustable wrench.
(11)
Remove the welded pipe of compressor inlet and outlet
and then remove the compressor.
Note: Recover refrigerant without spreading it in the air.
14. Removing the power receiver
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3)
Remove 2 front cover panel fixing screws (5 × 12) and
remove the front cover panel. (See Photo 3-1)
(4)
Remove 2 back cover panel fixing screws (5 × 12) and
remove the back cover panel.
(5) Remove the electrical parts box. (See Photo 3-1)
(6)
Remove 3 valve bed fixing screws (4 × 10) and 4 ball valve
and stop valve fixing screws (5 × 16) and then remove the
valve bed.
(7)
Remove 3 right side panel fixing screws (5 × 12) in the
rear of the unit and then remove the right side panel.
(8) Recover refrigerant.
(9) Remove 4 welded pipes of power receiver inlet and outlet.
(10) Remove 2 receiver leg fixing screws (4 × 10).
Note: Recover refrigerant without spreading it in the air.
Photo 13
OPERATING PROCEDURE
PHOTOS
OCH533A