#1
- Remove the screws on Right and Left Side
(3 screws) from the top cover. Slip bracket between
the top and side of chassis; reinstall the cover and
re-fasten with screws that were taken out.
Install screws provided
into top angle
#3
- Install "L" angle on the
inside of the right hand gable
using 3 pcs of the screws supplied
#2
- Remove the two existing screws
and install left hand side gable.
Refasten with the two screws just taken out.
#4
- Install the right hand gable by inserting lip of
screen between right side of black plastic grill and
back edge of chassis. Rotate side gable clockwise
and secure at top angle with screws supplied.
#5
- Install bottom angle slipping
under black plastic grill. Fasten both
sides of gable with screws supplied.
NOTE:
Wind Blockers are used to prevent direct wind exposure to the heat exchanger.
Windscreens are needed for the operation where the ambient temperature falls below -5° Celsius.
#7
- Secure Safety Cables to the Cabinet
chassis with existing cabinet screws
(as shown) and tighten up the 2 screws
already installed on the Front Face Panel
#6
- Install the Rear Face
Panel with screws supplied.
INSTALLATION PROCEDURE
PRE-12-18_201702
PRE-12-18 (REAR WINDSCREEN)
