- 8 -
3-11. Installation of the thread stand
(1) Assemble the parts (No.1 to No.11) of the thread stand as shown on the figure.
(2) Fit the thread stand into the hole at the far right on the table stand with the nut (No.13) and the
washers (No.12).
3-12. Installation of the chain for manual work holder presser
(1) Remove the X-Y motor cover.
(2) Link the machine head arm (No.1) and the pedal (No.2) on the stand side with the chain (No.3).
[Notice] Please make sure to unfasten the chain when tilting the machine. Tilting the machine head linked
with the chain causes the chain to be burst or the like.
<1>
<12>
<3>
<4>
<6>
<7>
<8>
<9>
<2>
<10>
<11>
<5>
<13>
<1>: Upper column pipe
<2>: Lower column pipe
<3>: Spool stand base (two stand bases)
<4>: Spool mat (two mats)
<5>: Spool holder (two holders)
<6>: Spool shaft (two shafts)
<7>: Spring washer (two washers)
<8>: Nut (four nuts)
<9>: Thread hunger
<10>: Spool holder
<11>: Column joint
<12>: Washer
<13>: Nut
<1>: Arm
<2>: Pedal
<3>: Chain
<2>
<3>
<1>
