9
9. Operation Manual for IR wireless remote controller
<To Stop Operation>
Press the ON/OFF button
again.
• The ON lamp
and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about three minutes.
This is to prevent the internal components from being damaged.
˚F
COOL
<To Start Operation>
Press the ON/OFF button
.
• The ON lamp
and the display area come on.
9.2.2. Temperature setting
To decrease the room temperature:
Press button
to set the desired temperature.
The selected temperature is displayed
.
To increase the room temperature:
Press button
to set the desired temperature.
The selected temperature is displayed
.
• Available temperature ranges are as follows:
Cooling/Drying:
19 - 30 °C, 67 - 87 °F
Heating:
17 - 28 °C, 63 - 83 °F
Automatic:
19 - 28 °C, 67 - 83 °F
• The display
flashes either 8 °C - 39 °C, 46 °F - 102 °F to inform you
if the room temperature is lower or higher than the displayed tempera-
ture. (This display does not appear on the wireless remote controller.)
9.2. Operation
9.2.1. Turning ON/OFF
9.2.3. Fan speed setting
Press the Fan Speed button
as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is
shown at
.
• The change sequence, and the available settings, are as follows.
FAN SPEED
Display
4-speed
+
Auto
3-speed
+
Auto
Speed 1
Speed 2
Speed 3
Speed 4
Auto
Speed 1
Speed 2
Speed 3 Auto
Remote controller
Display
Wired type
(PCA-KA4)
(PKA-HA4)
IR Wireless
remote controller
Swing
Auto
1
2
3
4
5
Swing
2
3
4
1
9.2.4. Airflow direction setting
<To Change the Airflow’s Up/Down Direction>
With the unit running, press the Airflow Up/Down button
as necessary.
• Each press changes the direction. The current direction is shown at
.
• The change sequence, and the available settings, are as follows.
COOL
9.3 Timer
Press the
or
button (TIMER SET).
• Time can be set while the following symbol is blinking.
OFF
timer:
A
is blinking.
ON
timer:
A
is blinking.
Use the
and
buttons to set the desired time.
Cancelling the timer.
To cancel the OFF timer, press the
button.
To cancel the ON timer, press the
button.
• It is possible to combine both OFF and ON timers.
• Pressing the
ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
• If the current time has not been set, the timer operation cannot be
used.