2
CENTRALLY CONTROLLED
DAILY
AUTO OFF
REMAINDER
CLOCK
ON
OFF
˚C
FILTER
˚C
1Hr.
NOT AVAILABLE
STAND BY
DEFROST
PAR-F27MEA
ON/OFF
CENTRALLY CONTROLLED
DAILY
AUTO OFF
REMAINDER
CLOCK
ON
OFF
˚C
CHECK MODE
FILTER
TEST RUN
LIMIT TEMP.
˚C
1Hr.
NOT AVAILABLE
STAND BY
DEFROST
FILTER
CHECK TEST
TEMP.
TIMER SET
CLOCK
→
ON
→
OFF
“CENTRALLY CON-
TROLLED” display
Displayed when air conditioner
operation is prohibitted by a cen-
tral controller, etc. When the re-
mote controller buttons are
locked, this display flashes.
“Current/Starting/
Ending/REMAINING
time” display
Displays the current time and
timer set times.
When the timer is operating, dis-
plays the normal time and the
stating, ending, or remaining
time.
“TIMER” “DAILY”
“AUTO OFF” Display
Displays the timer mode when
the timer is set.
There are three timers modes:
1 day timer, daily timer, and auto
off timer. One of these modes
can be selected.
“Airflow” display
Displays the outlet air direc-
tion.
“Louver” display
Displays operation of the
swing louver. It is not dis-
played when the louver is
stopped.
“ ” display
Displayed while the power is on.
“FILTER” display
Indicates that it is time to
clean the filter.
“Ventilation” display
Displayed during fan operation.
“NOT AVAILABLE”
display
When the button of a function
that is not installed at the indoor
unit was pressed, this display
flashes simultaneously with the
corresponding function display.
“Operation mode”
Displays the operation mode.
“Set temperature”
display
Displays the set temperature.
(For description purposes, all the
displays are assumed to be on.)
“Set effective for 1 hr.”
display
Displayed when low downward
is selected at cooling and elec-
tronics dry operation.
(Differs with the model.)
After one hour, the display goes
off, and swing also switches.
“Wind speed”
display
Displays the selected wind
speed.
DISPLAY SECTION
OPERATION SECTION
ON/OFF lamp
ON/OFF button
FILTER button
Wind speed button
CHECK button
(Normally not used)
TEST RUN button
(Normally not used)
Airflow button
Louver button
Ventilation button
Built-in temperature sensor position
When an operation button is pressed, if the indoor unit does not have that function, “NOT AVAILABLE” flashes.
When one remote controller controls multiple indoor units, if the master indoor unit has the selected function, this message is not displayed.
Open the door.
NOTE
2
Part Names
Timer selection button
Mode selection button
TEMP. buttons
(
▼
) Lower (
▲
) Raise
(
▼
) Return (
▲
) Ahead
“Room temperature”
display
Displays the intake temperature
while the air conditioner is op-
erating.
“Senser” display
Displayed when the remote
controller sensor is used.
Time selection buttons