23
GB
7-1-3. Canceling the initial setting mode
• Press the FILTER sign reset switch and
horizontal blow switch simultaneously (for at least two
seconds) when the group settings and linked equipment settings have been completed.
• This will store the group setting information and perform system start-up communications. Once this
has been completed, the user operation screen will be displayed. (Refer to 7-1.
1
(ii))
NOTE: Do not switch off the power supply during system start-up communications (when [H1] is
blinking.)
(The group setting information will be stored incomplete if the power supply is cut off.)
7-1-4. Collective deletion
Deletes all group setting information and interlocked unit setting information.
(1)
Display the initial setting mode screen or the interlocked unit setting screen.
(2)
Press the
fan speed switch with this displayed for three or more consecutive seconds to
delete all setting information.
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
Communications process for collective deletion in
progress
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
Initialized status
7-2. Setting the slave controller
• Initial settings are performed with the master system controller when this equipment is controlled by
the master system controller.
(It is not necessary to enter initial settings.)
NOTE: Observe the system limitations mentioned in *1 of 2. Functions when making the initial settings
with the master system controller.
[
] will blink in the room temperature display area
Press the
fan speed switch for three or more
consecutive seconds
The
ON/OFF
switch LED and the selection mark will blink
