Mitsubishi Electric NZ2GN2B1-32D, User Manual

Page: 131 / 268

6 INSTALLATION AND WIRING
6.6 Wiring of Connector for Module Power Supply and FG
129
6
6.6
Wiring of Connector for Module Power Supply and
FG
Applicable plugs
The following table lists plugs applicable to the connector for power supply and FG.
*1 One order of Mitsubishi Electric A6CON-  5P includes 10 plugs.
*2 One order of Mitsubishi Electric A6CON-  J5P includes 5 plugs.
*3 One-touch connector plugs cannot be reused once crimped.
*4 Check the outer diameter of the applicable cable before selecting a connector.
*5 The allowable current values of the cables connected must be observed.
*6 Contact (manufacturer of the plugs): 3M Japan Limited
Wiring procedure
Product name Model name of
Mitsubishi
Electric product Model name of
part
*6
Specifications Color of
the cover
Applicable cable
(core wire size) Applicable
cable
(outer
diameter) Maximum
rated
current
One-touch connector
plug for power supply
and FG
*1*3*4
A6CON-PW5P 35505-6080-A00 GF 0.75

(0.66 to 0.98

) (18 AWG)
0.16mm or larger for wire
diameter
Insulating coating material
PVC (heat resistant vinyl)

2.2 to 3.0mm 7A
*5
Gray
A6CON-PW5P-SOD 35505-6180-A00 GF

2.0 to 2.3mm Blue
Online connector for
power supply and FG
*2
A6CON-PWJ5P 35720-L200-A00 AK
   
1.
Checking parts of the connector
Check that the plug cover is attached to the plug body.
Do not push the plug cover into the plug body before
inserting cables. Once clamped, the plug cannot be reused.
2.
Inserting cables
Lift the rear part of the plug cover, and insert a cable fully to
the end of the plug cover.
If a cable is not inserted fully, it may cause a poor crimping.
The cables to be inserted must be applicable cables.
3.
Setting the plug cover
After inserting cables, push down the rear part of the plug
cover so that the plug cover is engaged with metal contacts.
Plug body
Metal contact
Plug cover
Metal contacts
Metal contacts