
Tips
Cleaning
Before cleaning, pull out the power plug, remove the main unit plug, and then wait until the main unit cools.
Cartridge
<Clean the cartridge after it has cooled down>
Rinse it with water and then wipe off the water.
*
Do not wash it with the nylon surface of a cleaning
sponge (doing so may cause damage).
How to remove the
cartridge
First remove the heat
sink.
1
Remove it while
holding the tab.
2
Release the 3 locks
(release the part).
3
Open the cartridge.
4
Remove the cartridge packing.
How to attach the cartridge
1
Attach the cartridge
packing.
*
Do not attach the packing
by twisting it (doing so
may cause steam to leak)
.
2
Insert the 4
claws into the
holes and close
the cartridge.
3
Engage the 3 locks.
4
Confirm that the cartridge
has a bush (see the figure
below) and attach the
cartridge to the main unit.
Insert the lower part and
then push in the upper part.
If you do not attach the cartridge, the heat sink cannot be attached.
How to attach the bush
Attach the bush correctly.
Not doing so may cause
boiling over.
Wash it
thoroughly
to ensure
tasty rice.
Wash it
thoroughly
to ensure
tasty rice.
Packing
(cannot
be
released)
Tab
Packing
(cannot
be
released)
Tab
Lock
Lock
Cartridge Packing
Release from
here
Cartridge Packing
Release from
here
Insert the packing into the
groove so that the circular
surfaces of the packing are
at the top and bottom.
Hole
Claw
Lock
Insert the packing into the
groove so that the circular
surfaces of the packing are
at the top and bottom.
Hole
Claw
Lock
Bush
Bush
Tank
<Clean the tank after it has cooled down>
Tank lid and tank container:
Rinse it with water and then wipe
off the water.
* Do not scratch the water level
sensor surfaces (inside and
outside)
Tank cover:
Wipe it with a well-wrung-out cloth.
How to remove the tank
1
Remove the tank from
the main unit.
2
Remove the tank lid
(remove it while holding the
part).
Pipe
Clean the
inside of the
pipe as well.
Check Valve
(inside the pipe)
Do not remove this part.
End
of the
Pipe
* Do not pull or turn the check
valve (doing so may cause steam
to leak).
3
Drain the water.
4
Place the tank on a
cloth and remove
the tank cover.
Hold the tank cover with
both hands and push it downward.
How to attach the
tank
1
Attach the tank
cover to the
tank container.
2
Attach the tank lid.
3
Insert the tank into
the main unit.
Water level sensor
Water level sensor
Align the 4
protruding parts
at the tank bottom
and push into the
main unit.
Align the 4
protruding parts
at the tank bottom
and push into the
main unit.
Clean the Parts after Use Every Time