31
PHOTOS
3. Removing the outdoor fan motor
(1) Remove the cabinet. (Refer to 1.)
(2) Disconnect the connector and remove the hooked lead
wire from the fan motor.
(3) Remove the propeller nut and remove the propeller.
(4) Remove screws fixing the outdoor fan motor.
(5) Remove the outdoor fan motor.
4. Removing the compressor
(1) Remove the cabinet. (Refer to 1.)
(2) Remove the relay panel.
(3) Remove the soundproof felt.
(4) Remove the terminal cover on the compressor.
(5) Disconnect lead wires from the glass terminal of the com-
pressor.
(6) Recover gas from the refrigerant circuit.
(7) Disconnect the welded part of the discharge pipe.
(8) Disconnect the welded part of the suction pipe.
(9) Remove nuts fixing the compressor.
(10) Remove the compressor.
NOTE
●
Before using a burner, reclaim gas from the pipes until the
pressure gauge shows 0 kg/cm
2
(MPa).
●
Use the burner under the condition that gas can be recovered
even when the inner pressure rises by heat.
Photo 5
Compressor
Discharge
pipe
Suction
pipe
Compressor set nuts
Photo 4
Hook
Propeller
Propeller nut
Soundproof felt
OPERATING PROCEDURE
OB370-2.qxp 04.10.14 1:46 PM Page 31
