5
1
1
2
E.O.
SW
The unit is set with auto-restart function, which is set to
OFF when the unit leaves factory. If you want to use the
function, contact the technical service center.
Auto-restart function refers
to the following contents:...
How to use the remote controller
The signal can travel up to 6 meters (in a straight
line)away from the frontal face of indoor unit.
At the time of pressing the button, the indoor unit
beeps once or twice to confirm the signal received. If
the unit doesn’t beep, press the button again.
Use the remote controller carefully.
If it falls down to the ground, is thrown or soaked in
water, malfunction may result.
Battery
Standard for replacing battery
Two new alkaline batteries (No.7, LR03) shall be
replaced in the following condition:
The indoor unit has no response to the signal sent
from the remote controller.
The display of the remote controller becomes light.
Please don't use manganese battery, or the remote
controller will be in failure.
The lifespan of a alkaline battery is about one year.
However, it's recommended to consider the expiration
date (year/month) at the bottom of a battery. If the
expiration date draws near, the battery should be
replaced as soon as possible.
In order to avoid fluid leakage, please take out the
battery if it is not used for a long time.
Note:
If the battery fluid splashes against skin or clothes,
please wash them with clear water carefully.
If the battery fluid splashes into eyes, please wash
them with clear water immediately and see a doctor.
Don't use rechargeable battery.
Two batteries shall be of the same type.
Obsolete batteries shall be disposed of properly.
When the indoor unit is controlled by the remote
controller, the unit will automatically remember the
operation mode, set temperature and fan speed. If
power cut or power-off occurs during operation, Auto-
restart function will enable the unit to start automatically
and operate in the previous mode set by the remote
controller after power-on.
When the remote controller can't
be used (emergency operation)
When the dry batteries in the remote controller are
exhausted, or when the remote controller is in failure, you
can use the emergency operation button on the unit to
control the operation.
Press the emergency operation button.
·
Each press of the button enables the unit to
change operation mode following the order of
Cooling
→
Heating
→
Stop.
·
The operation mode is indicated by the AREA
lamp on the indoor unit as follows:
·
The operation is described as follows:
The operation is described as follows. In the first
30 minutes, the unit only operates continuously
without impact from room temperature. The fan
speed is constant. After 30-minute operation, the
unit status is as follows:
Preparation before operation
Auto-restart function
Indoor unit
·
·
·
■
·
·
·
·
·
·
·
■
To stop the Emergency operation, press the
Emergency operation switch.
·
Each press of the button enables the unit to
change operation mode following the order of
Cooling →Heating →Stop.
Warning
Confirm a firm connection by removing the dust on the power plug.
Fire or electric shock may result from a plug with dust or socket in
failure.
Insert the power plug in the socket. Turn the power
switch to ON position.
NOTE:
This displayed in emergency operation.
Set temperature
Fan speed
Horizontal (vane)
Vertical vane
24
℃
Medium
Automatic
Front
Operation mode
Cooling
24
℃
Medium
Automatic
Front
Heating
Stop
Emergency
cooling
Emergency
heating
Operation indicator
Light
AREA
AREA
AREA
L
R
L
R
L
R
Black out
Black out Light
Black out Black out
■
Summary of Contents for MSZ-WG18VA-H1
Page 26: ......
