10-1. MSZ-FH09NA MSZ-FH12NA MSZ-FH15NA
NOTE:
Turn OFF power supply before disassembly.
OPERATING PROCEDURE
PHOTOS
1. Removing the panel
(1) Remove the horizontal vanes.
(2) Remove the front panel. Remove the screw caps of
the under panel. Remove the screws of the under
panel.
(3) Pull out the right top corner of the right panel and
remove the right panel.
(4) Pull out the left bottom corner of the left panel and
remove the left panel.
(5) Unhook the lower part of the under panel and
remove the under panel.
Photo 1
Photo 2
32
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
DISASSEMBLY INSTRUCTIONS
10
Front panel
Horizontal vanes
Removal procedure
Unlock
Upper and
lower vanes
Unlock the upper and lower vanes as shown
in using a thin instrument.
Then, remove the horizontal vanes in the
direction of .
Horizontal vanes
Screws of the under panel
Right panel
Under panel
Screws of the panels
Left panel
OBH683B
