38
B Check of remote controller and indoor electronic control P.C. board
*Check if the remote controller is exclusive for this air conditioner.
Does the unit operate with the remote
controller?
OK
Yes
No
(Not clear)
Replace the batteries. (Refer to 10-1.4.)
Press OFF/ON (stop/operate) button on
the remote controller.
Is LCD display on the remote controller
visible?
Remove the batteries, then set them back
and press RESET button. (Refer to 10-1.4.)
Check if the unit operates with the remote
controller.
Yes
No
Turn ON a radio to AM and press OFF/ON
(stop/operate) button on the remote con-
troller. *1
Is noise heard from radio?
Yes
No
Replace the remote controller.
Are there any fluorescent lights of
inverter or rapid-start type within the
range of 1 m? *2
Yes
No
• Reinstall the unit away from lights.
•
Attach a filter on receiving part.
Replace the indoor electronic control
P.C. board. (Including the receiver)
*1 Look at the image of the signal transmitting section of
the remote controller through the monitor of a digital
camera or a camera phone. It is normal if the LED of
the signal transmitting section lights up when the OFF/
ON (stop/operate) button on the remote controller is
pressed. However, it may be difficult to see the illumi
-
nated LED of the signal transmitting section with a
smartphone camera.
*2 If the inverter fluorescent light is turned on when the
room is cool, the unit may have difficulty receiving the
signal from the remote controller or may not be able to
operate with it; if the inverter fluorescent light is turned
on when the room is warm, the unit may be able to
operate with the remote controller.
OBH932
