ON-VEHICLE SERVICE
TSB Revision
ACTIVE STABILITY CONTROL SYSTEM (ASC)
35C-145
IN THE EVENT OF A DISCHARGED 12V STATER BATTERY
M1355006200221
WARNING
If the ASC is not operating, the vehicle will be
unstable during braking, Do not drive the
vehicle with the ASC-ECU connector discon-
nected or with the ASC not operating.
If the electric motor unit is started using a booster
cable when the 12V Stater battery is completely flat,
and the vehicle is then driven without waiting for the
12V Stater battery to be recharged, the electric motor
unit may misfire and it may not be possible to drive
the vehicle. This is because the ASC consumes a
large amount of current when carrying out its initial
checks. If this happens, recharge the 12V Stater bat-
tery fully.
STEERING WHEEL SENSOR CALIBRATION
M1355009200316
CAUTION
After the next operation has been completed,
carry out the following two operations:
•
Alignment adjustment <Front>
•
Steering wheel sensor (column switch assem-
bly) replacement, removal, installation
1.
Update the neutral position stored in the
steering wheel sensor.
2.
Reset the calibrated value of the steering
angle stored in ASC-ECU.
CAUTION
•
Before performing the calibration, check if the
steering wheel sensor-related DTC is set in
ASC-ECU.
•
When the DTC other than C1394 is set, carry
out the inspection according to each trouble-
shooting procedure.
.
1. Park the vehicle on a level surface with tires and
steering wheel positioned in a straight ahead
direction.
2. Turn the electric motor switch to the "ON"
position.
3. Turn the electric motor switch to the "LOCK"
(OFF) position.
CAUTION
Before connecting or disconnecting scan tool,
always turn the electric motor switch to the
LOCK (OFF) position.
4. Check that the electric motor switch is in the
"LOCK" (OFF) position, and then set scan tool.
5. Turn the electric motor switch to the "ON"
position.
6. On the Menu, select "System selection."
7. In "System table" of "System selection," select
"Steering angle sensor," and then press the "OK"
button.
8. In "Steering angle sensor," select "Special
function."
9. In "Special function," select "Learn neutral
position of steering angle sensor."
NOTE: When the neutral position of steering
angle sensor has been learned, "Neutral position
learned already: in order to relearn the neutral
position, press the "OK" button to initialize the
steering angle sensor neutral position." is dis-
played. If it is okay, press the "OK" button.
10.In "Learn neutral position of steering angle
sensor," "Initialize neutral position of steering
angle sensor" is selected, thus press the "OK"
button.
NOTE: When the neutral position of steering
angle sensor has been learned, "Initialize neutral
position of steering angle sensor: Do you want to
execute? Note: The DTC will be erased." is dis-
played. Then, press the "OK" button.
11."Initialize neutral position of steering angle
sensor: Completed" is displayed. Then, press the
"OK" button.
12.Press the "OK" button.
13."Learn neutral position of steering angle sensor:
Do you want to execute? Note: Execute after the
tires and steering wheel are aligned in a straight
ahead direction." is displayed. Then, press the
"OK" button.
14."Learn neutral position of steering angle sensor:
Completed" is displayed. Then, press the "OK"
button.
MSB-20EXML35-501(20AB039)
9
<Incorrect>
update the neutral position stored in the
steering wheel sensor.
<Correct>
<Deleted>
<Deleted>
Attached sheet 6 (1/2)
