E-267
OPTIONAL
P
AR
TS
Enables operation even when the outside tempera-
ture is low. Protect the unit from cold wind.
Photo
Specifications
PUHZ-ZRP100,125,140VKA3
PUHZ-P100,125,140VKA
1 piece required
PUHZ-ZRP200,250YKA3
PUHZ-P200,250YKA3
2 pieces required
Air Protect Guide
Descriptions
Applicable Models
Dimensions
Unit: mm (inch)
Alloy hot-dip zinc-coated carbon steel
sheet
Ivory (3.0Y 7.8/1.1)
Color (Munsell)
Material
Weight
3.5kg
Accessory name x Qty.
<Material/Surface treatment>
Washer faced screw (M5x15) x 4
<Iron wire (SWCH18A)/Zinc nickel
plated>
Exterior
Acrylic resin coating
Surface treatment
(for cooling at -15 )
* Air Guide prevents reverse rotation of outdoor unit fan when it enters low speed rotation mode with fan controller
being operated. It is also used for protection of fan when strong winds, such as a typhoon, wind blowing through tall
buildings, etc., directly strike the air outlet. In addition, installation of this product is necessary when cooling opetation
is to be performed in outdoor tempreture of -5
℃
or lower (down to -15
℃
).
Note the followings when installing this guide:
1) Be sure not to use "upward discharge" in a place where snowing is possible. Snow may accumulate in the
guard, which could damage the fan, etc.
2) Attaching this unit will decrease the performance (by 2-3%) and increase noise from outdoor unit (by approx. 1-2 dB).
3) Do not use "upward discharge" when there are any obstacles at the back and on both sides of outdoor unit
(air is taken in from top of unit): This could cause a short cycle.
4) To eliminate the influence of external wind, be sure to install the unit with its back facing to wall.
5) Do not install this unit in a place where wind directly blows to the back of the unit.
CAUTION
638(Installation pitch of outdoor unit)
653
102.5
155
16
40
150
10
586
R20
R30
R20
R20
150
150
48
48
627.8
285
(Installation pitch
of outdoor unit)
285
(Installation pitch
of outdoor unit)
6-ø7 hole
200
PUZ-ZM100,125,140VKA
PUZ-ZM200,250YKA
PUZ-M200,250YKA
2 pieces required
PUZ-M100,125,140VKA
1 piece required
[R410A type]
[R32 type]
