16
8
DISASSEMBLY PROCEDURE
PKFY-P32VGM , PKFY-P40VGM , PKFY-P50VGM
OPERATION PROCEDURE
PHOTOS & ILLUSTRATION
1 REMOVING THE LOWER SIDE OF THE INDOOR UNIT
FROM THE INSTALLATION PLATE
(1) Remove the left / right corner box of the indoor unit.
(2) Hold and pull down the lower and both ends of the indoor
unit, and remove the
▼
section from the square hole.
(Refer to Figure 2.1)
Or remove the front panel and push the
▼
section down
by using alankey ,etc. from the front side.
(Refer to Figure 2.2).
(3) Unhook the top of the indoor unit from the back plate catch.
2 REMOVING THE FRONT PANEL
(1) Open the front grille.
(2) Remove the terminal block cover with a screw.
(3) Remove the screw 3 caps then remove the set 3 screws.
(4) After removing the lower side of the front panel a little,
remove it as pulling toward upper.
3 REMOVING THE INDOOR CONTROLLER BOARD
(1) Remove the terminal block cover.
(2) Remove the front panel. (See Photo 1)
(3) Remove the electrical parts box (2 screws).
(4) Remove the electrical parts box cover (1 screw).
(5) Disconnect the connector on the indoor controller board and
remove the controller board by pulling up the hook of the
controller
case.
w
For a smooth work, hang the side hooks of the electrical
parts box on the hook of the motor cover.
(See Photo 3)
(Figure 1)
(Figure 2.1)
(Figure 3)
(Photo 1)
(Photo 2)
(Figure 2.2)
Square hole
Hook
Square hole
Hook
Terminal block cover
Front grille
Front
panel
Set screw
Set screw
Electrical parts
box
Set screw
Motor cover
Electrical parts
box hook
w
(Photo 3)
Hook
Electrical parts box
Controller case
Indoor control
P.C. board
Up
Down
OC179B
Summary of Contents for Mr.Slim PKFY-P32VGM
Page 21: ...21 OC179B ...
