61
DISASSEMBLY INSTRUCTIONS
11
11-1. MSZ09UN
INDOOR UNIT
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector is a terminal
with lock mechanism
1
Slide the sleeve.
2
Pull the terminal while
pushing the locking
lever.
1
Hold the sleeve, and
pull out the terminal
slowly.
In case of terminal with lock mechanism, detach the terminal as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with lock mechanism.
The terminal with no lock mechanism can be removed by pulling it out.
Check the shape of the terminal and work.
<"Terminal with lock mechanism" Detaching points>
Connector
Sleeve
Locking lever
OPERATING PROCEDURE
PHOTOS
Photo 1
Photo 2
Screws
Front panel
Indoor electronic
control P.C. board
Screw of the termi-
nal block
1. Removing the front panel
(1) Remove the screw caps at the bottom of the front panel.
Remove the screws.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
2. Removing the electronic control P.C. board and the
power monitor, receiver P.C. board
(1) Remove the front panel. (Refer to 1.)
(2) Remove the screw of the electrical cover.
Remove the electrical cover.
(3) Remove the screw of the terminal block.
(4) Disconnect all the connectors and all the lead wires on the
electronic control P.C. board.
(5) Remove the electronic control P.C. board.
(6) Remove the R.L holder.
(7) Open the R.L holder and remove the power monitor,
receiver P.C. board.
R.L holder
Power monitor,
receiver P.C.
board
Screw of the
electrical cover
OB297--3.qxp 04.2.4 4:22 PM Page 61
Summary of Contents for Mr.Slim MSZ09UN W
Page 75: ......
