5
4. Operation System
1. Temperature Control
3. Electrical Connections
Important: For personal safety, this appliance must be properly grounded.
The refrigerator should always be plugged into its own individual electrical outlet.
This is recommended for best performance and also in order to prevent the overloading of household wiring
circuits, which may cause a fire hazard. Extension cords are not recommended.
Make sure that the outlet provides the correct voltage.
If your refrigerator has a grounding plug, use it correctly. The 3-pin plug must be inserted into a mating
3-pin grounded receptacle. If the installation location does not have a proper 3-pin grounding wall
receptacle, the proper type must be installed. The ground point should never be cut or removed.
If your refrigerator has an ungrounding plug, connect the ground wire to the ground connection screw
provided at the lower rear side of the refrigerator.
Since it takes time to cool down, please insert
the electrical plug as soon as possible.
It normally takes about 4 - 5 hours to cool down.
If you insert the electrical plug immediately after
installation, it will not cause damage to your unit.
To cool the unit quickly
When inserting food, make sure to allow some space
between items.
Put in warm food items or ice cream after the refrigerator
has been adequately cooled down.
Keep opening and closing of the door to a minimum,
and keep it open for only a short time.
In the summer time when it’s hot, it will take approx.
24 hours to make the first batch of ice.
CAUTION
The appliance is not intended for use by young
children or infirm persons without supervision.
Children should be supervised to ensure that the
refrigerator is used properly.
How to adjust temperature
※
Normally should be in the "MID" position
(Definition of) Status light = On = Flickering = Off
※
Level Status light Temperature
About 7
o
C
About 4
o
C
About 1
o
C
About -2
o
C
About -5
o
C
LOW
LOW-MID
MID
MID-HIGH
HIGH
To cool more or when too cold
Press or to adjust the temperature
Green light on Temperature Control Display will move as you press
Temperature adjustment position and temperature level
About 7
o
C
About 6
o
C
About 5
o
C
About 4
o
C
About 3
o
C
About 2
o
C
About 1
o
C
About 0
o
C
About -1
o
C
About -2
o
C
About -3
o
C
About -4
o
C
About -5
o
C
The status light of "Precisely Adjustment Mode" Temperature
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
How to adjustment the temperature precisely
※
Able to adjust precisely
1. Hold and simultaneously for 5 seconds to enter "Precisely
Adjustment Mode"
2. Adjust the temperature precisely by pressing or .
The temperature can be changed by 1
o
C of each adjustment. Detail of each
level is demonstrated in table on the right. (light flickers every 2 seconds)
3. To cancel "Precisely Adjustment Mode", please hold and simultaneously
for 5 seconds. The status light will turn back to the same position.
(In case that status light still flickering, "Precisely Adjustment Mode" is
not completely cancelled. Please check following the instruction again)
(Definition of) Status light = On = Flickering = Off
※
