22
Silver Ion Filter, Air Intake, and Sensor
Clogging with dust and the like reduces the effectiveness of the dehumidifying. Clean once every two weeks.
Maintenance
Do not use detergents, cleaning agents for heat exchange equipment, abrasive powders, chemically treated dusters,
gasoline, benzene, thinners or other solvents, as they can damage the unit or the water tank, which may result in leakage.
Remove any dust from the white net
surface with the nozzle of a vacuum
cleaner.
Do not use a nozzle with a brush. This may
damage the fi lter.
When the fi lter is very dirty
Soak the fi lter in water.
Remove the fi lter cover
1
Pull forward to remove.
Performance is unaffected even if the metal fi ns
inside the main unit are slightly bent.
Remove the silver ion fi lter
from the fi lter cover, and then
clean the fi lter.
2
Silver ion fi lter
Filter cover
Clean the air intake and
sensor
3
Remove any dirt
with a vacuum
cleaner.
Sensor
Air intake
Do not use a nozzle with a brush. This may
damage the fi lter.
Set the silver ion fi lter into
the fi lter cover
4
Make sure the silver ion fi lter is attached to
the unit. If it is not, fi ne dust will enter inside
the unit and cause a malfunction.
Set the fi lter cover.
5
Insert the bottom
tabs into the unit
until they click.
Once Every Two Weeks
Align the white net surface with the fi lter cover,
set the fi lter inside the tabs, and fi x the fi lter in
place with the centre tabs.
Preparation
Press the POWER switch to turn off the
power, wait until the blower fan stops rotating
(approximately 2 minutes) before unplugging the
power cord.
Tabs
Outer side: 12
Centre: 2
(
)
e̲mj̲15bx̲a1.indb 22
e̲mj̲15bx̲a1.indb 22
2008/08/19 17:58:49
2008/08/19 17:58:49
