Mitsubishi Electric MELSEC iQ-R Series, Programming Manual

Page: 190 / 2110

188
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
Annunciator
OUT F
This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
■ Execution condition
Setting data
■
Description, range, data type
*1 Only labels assigned to the annunciator can be used.
■
Applicable devices
*1 Only F can be used.
Processing details
• This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
• When the annunciator (F) is turned on by this instruction, the following are performed.
• If the value in SD63 is 16 (meaning 16 annunciators are already on), the annunciator number will not be stored in the
special register (SD64 to SD79) even when a new annunciator turns on.
• When the annunciator (F) is turned off by this instruction, the following are performed.
Operation error
There is no operation error.
Ladder ST
ENO:=OUT(EN,d);
FBD/LD
(  is to be replaced by OUT.)
Instruction Execution condition
OUT F Every scan
Operand Description Range Data type Data type (label)
(d) Target annunciator number  Bit ANY_BOOL
*1
EN Execution condition  Bit BOOL
ENO Execution result

Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY J  \  T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD U  \G  , J  \  ,
U3E  \(H)G 
Z LT, LST,
LC LZ K, H E $
(d)

*1
          
• The USER LED of the CPU module turns on.
• The annunciator number (F number) to be turned on is stored in the special register (SD64 to SD79).
• The value in SD63 is incremented by one.
• The coil turns off, but the USER LED status and the data in SD63 to SD79 remain unchanged.
• To turn off the USER LED or delete the annunciator number that has been turned off by this instruction from SD63 to SD79, use the RST F instruction.
RnCPU RnENCPU
RnSFCPU RnSFCPU RnPCPU RnPCPU
(Standard) (Safety) (Redundant) (Process)
(d)
EN ENO
d