Mitsubishi Electric LC62 CHASSIS XL6500LU, User Manual

Page: 10 / 50

EN-10
Setting up your projector
Setting up the screen
Install the screen perpendicularly to the projector. If the screen can not be installed in such a way, adjust the
projection angle of the projector. (See page 11.)
• Install the screen and projector so that the projector’s lens is placed at the same height and horizontal position of
the screen center.
• Do not install the screen where it is exposed to direct sunlight or lighting. Light directly refl ecting on the screen
makes the projected images whitish and hard to view.
Screen size and projection distance
Refer to the following table to determine the screen size and projection distance.
L
L
I
W1 W1
H1
H
W
L
L
I
W1 W1
H1
H
W
Center of the lens*
Center of the lens*
Maximum projection area
Maximum projection area
*: Center of the lens when the image is projected
along the top of the maximum projection area
*: Center of the lens when the image is projected
along the bottom of the maximum projection area
Front projection Front projection, ceiling mounting
• Depending on the installation conditions, warm air that is emitted from the exhaust vents may fl ow into the intake
vent, causing the projector to display “TEMPERATURE!!” and then stop projecting images.
For XL6600U and XL6500U only. For XL6600LU and XL6500LU, see page 48.
Screen size Projection distance (L) Lens shift height
Lens shift
width
(W1)
Diagonal size
Width
(W)
Height
(H)
Shortest
(Wide)
Longest
(Tele)
Standard
(I)
Movement
distance (H1)
inch cm inch cm inch cm inch m inch m inch cm inch cm inch cm
60 152 48 122 36 91 89 2.3 114 2.9 1.8 5 16.6 42 2.5 6
80 203 64 163 48 122 120 3.0 153 3.9 2.4 6 22.0 56 3.3 8
100 254 80 203 60 152 150 3.8 191 4.9 3.0 8 27.4 69 4.1 10
150 381 120 305 90 229 227 5.8 289 7.3 4.5 11 40.9 104 6.1 15
200 508 160 406 120 305 304 7.7 386 9.8 6.0 15 54.4 138 8.1 20
250 635 200 508 150 381 381 9.7 483 12.3 7.5 19 67.9 172 10.1 26
300 762 240 610 180 457 458 11.6 - - 9.0 23 81.4 207 12.1 31
The above fi gures are approximate and may be slightly different from the actual measurements. •