—31—
Assembly precautions
• Replace the packing used in the disassembled section with
a new one.
• Take care not to twist the packing when replacing it.
7
Remove the board fix plate (back) clamping screws.
(Two PTT screws 4 x 16, indicated by
O
)
Assembly precaution
Secure the light receiving circuit board firmly with the claws.
8
Remove the light receiving circuit board from the board fix
plate (back).
(Release the board from the claws at four places: indicated by
O
O
)
Assembly precautions
• When setting the light receiving circuit board on the board
fix plate (back), confirm the correct mounting direction of
the board. (See photograph.)
• After installing the circuit board, confirm that the LEDs are
not tilting.
Assembly precaution
Run the lead wires within the groove on the side of the base.
(Indicated by
O
)
(8) Heater unit
1
Remove the control circuit board. See (4)
1
~
7
.
2
Remove the casing clamping screws.
(Two special screws 4 x 16, indicated by
O
)
Summary of Contents for JT-SB216ESH-DG-CE
