EN-26
•
About glasses(Liquid Crystal Shutter)
•
Do not press the glasses too hard; and also do
not fall on or bend them.
•
Do not scratch the surface of the glasses with
anything sharp.
•
About infra-red transmission
•
Do not contaminate the infra-red transmission
and do not apply anything on it, because it
makes the 3D infra-red transmission device not
receive the signals and the glasses not operate
normally.
•
If there is other infra-red communication
equipment interference, the 3D images can not
be seen.
•
The 3D Glasses may operate incorrectly when
using the remote control, but this is not a failure.
If you stop the operation of the remote control, it
will return to normal.
•
When you view 3D images, sometimes the
remote control is out of order, but this is not
failure.
The above figures are approximate and may be slightly different from the actual measurements.
Place the 3D Emitter so that you can use the 3D Glasses within the transmission range described above.
Normally, attach the 3D Emitter to the projector as described on page 27.
However, if the 3D Glasses don’t receive the signal properly when you attach the 3D Emitter to the projector, place the 3D
Emitter according to the procedure described on page 27.
•
Do not put any object which obstructs the communication between the 3D Emitter and the 3D Glasses.
•
Do not place the 3D Emitter near the remote control sensor of other devices.
•
The transmission distance is decreased when the infra-red signal from the 3D Emitter is transmitted to the 3D Glasses by
reflecting on the screen. In addition, the transmission distance in such case varies depending on the characteristics of the
screen.
This 3D Emitter transmits the Infra-red signal in the range illustrated below.
•
Placement and connection of 3D Emitter
•
About 3D Emitter (EY-3D-EMT1)
•
Using 3D Glasses
•
Do not use the machine which can generate
electromagnetic waves (such as mobile
telephone, etc.) near the 3D Glasses ,which may
cause incorrect actions of glasses.
•
Use it b32°F (0°C) to +104°F (+40°C).
•
If you view in a room using a fluorescent lamp,
the whole light in the room seems to blink.
Therefore, the unit shall be placed as far from
the fluorescent lamp as possible. If it continues,
shut off the fluorescent lamp.
•
Wear the 3D Glasses correctly. If not, you will
not view the correct three-dimensional images.
•
It is not clear to see other screens (such as
computer images, digital clock, calculator, etc.)
with the 3D Glasses, therefore, take off the 3D
Glasses when viewing other images.
•
The 3D Glasses are not sunglasses, so do not
use as sunglasses.
•
Do not use the 3D Glasses given at the cinema.
•
You cannot see the 3D images when you lie
down with the 3D Glasses.
View from the side
View from the top
The transmission angle can
be adjusted vertically in five
steps by switching the angle
of the transmission part.
Viewing 3D images (continued)
Infra-red transmission part
This part transmits the Infra-red signals.
The transmission angle can be adjusted
vertically in five steps.
Base part
3D Emitter terminal
Connect this terminal to the 3D
EMITTER terminal on the projector
using the supplied mini DIN 5 pin
cable .
