Mitsubishi Electric GT16, User Manual

Page: 950 / 1306

47 - 14
47. CONNECTION TO FUJI PLC
47.2 Serial Connection
(a) Setting of the MODE
Make the MODE settings using the MODE switch.
(b) Setting of Transmission speed, Stop bit, Data bit,
Parity bit, Initializing method

Connecting to NC1L-RS4
(1) Communication settings
Make the communication settings using setting switches.
*1 Adjust the settings with GOT settings.
*2 Avoid duplication of the station No. with any of the other
units.
*3 Turn ON the terminating switch of a general-purpose
interface module which will be a terminal.
(2) Settings by switch
Make the communication settings using each setting switch.
(a) Setting of the MODE
Make the MODE settings using the MODE switch.
(b) Setting of the station No.
Make the station No. using RS-485 station No.
switches.
(c) Connecting terminating resistors
Turn ON/OFF the terminating resistor using RS-
485 terminating resistor ON/OFF switch.
MODE
Switch position
NV1L-RS2 NC1L-RS2
Command-setting-type
start-stop
synchronization,
nonsequence format
1 1
Setting item Set value
Switch No.
1 2 3 4 5 6 7 8
Transmission
speed
9600bps ON OFF ON
19200bps OFF ON ON
Stop bit
1bit ON
2bits OFF
Data bit
7bits ON
8bits OFF
Parity bit
Even ON
Odd OFF
Done ON
None OFF
Initializing
method
By switch ON
For the NV1L-RS2 For the NC1L-RS2
Item Set value
MODE
Command-setting-type start-stop
synchronization, nonsequence format
Transmission speed
*1
9600bps, 19200bps
Data bit
*1
8bits or 7bits
Parity bit
*1
Even or Odd
Done, None
Stop bit
*1
1bit, 2bits
Initializing method By switch
Station No.
*1*2 0 to 99
Terminating resistor
*3
ON or OFF
MODE Switch position
Command-setting-type start-stop
synchronization, nonsequence
format
3
Station No.
0 to 99
MODE switch
RS-485 station No.
switches
Terminator switch
Character configuration
switches
(Front view) (Rear view)
ON