Mitsubishi Electric GT14, User Manual

Page: 1457 / 1546

56
CONNECTION T
O
L
S
IN
DUST
R
IA
L
SY
STEMS PLC
57
CONNECTION T
O
SI
CK SAFE
T
Y
CONTROL
LER
58
CONNE
C
T
ION T
O
SI
EME
N
S PLC
59
CON
N
ECT
ION
T
O
HI
RA
TA
C
O
RPOR
AT
ION
HN
C C
O
NT
ROL
LE
R
60
CONNECTION
T
O
MURA
TEC
CONT
ROLLE
R
61
MICROCOMPUTER C
O
NNECTION
(SERI
A
L)
62
MICROCOMPUTER CONNECTION (ETHERNET)
63
MODBUS
(R)/
R
T
U
CONNECTION
62. MICROCOMPUTER CONNECTION (ETHERNET)
62.3 Device Data Area
62 - 11
62.3.6 SM devices
The SM devices are bit devices into which interrupt outputs and clock data that turn ON/OFF at 1-second cycles.

List of SM devices
The following shows the SM devices (virtual devices inside the GOT).
*1 After the ON/OFF state is changed, the interrupt data are output within a period of 1 to 10ms.
*2 When the ON/OFF state of SM0 to 49 is changed from the host side, interrupt output is not performed.
POINT POINT POINT
(1) The side where virtual devices are set
System: Set on the system side.
User: Set on the user side (by sending request messages from host or using the touch switches, etc. on the GOT).
(2) Interrupt outputs (SM0 to 49)
• To disable the interrupt output, turn ON SM52 (interrupt code output disable flag). ( 62.3.6 SM devices)
• To issue interrupts, set the data length to "8 bits" at "Communication Detail Settings".
( 62.5.1 Setting communication interface (Communication settings))
• When "7 bits" is set, the MSB (8th bit) is ignored. (Example: FF
H
7F
H
)
Address Description Set side
SM0 to 49
Interrupt output
When the ON/OFF state of SM0 to 49 is changed by a touch switch on the GOT, for example, the interrupt
codes shown below are transmitted (interrupt output) to the host side.
*1*2
The data amount (number of bytes) to be interrupt-output is set at "Interrupt Data Byte" in "Communication
Detail Settings". ( 62.5.1 Setting communication interface (Communication settings))
User
SM50
1-second cycle clock
Turns ON/OFF at a 1-second cycle.
System
SM51
2-second cycle clock
Turns ON/OFF at a 2-second cycle.
SM52
Interrupt code output disable flag
Enables or disables the output of the interrupt code.
OFF: Interrupt code output enabled ON: Interrupt code output disabled
When set to disable the interrupt code output, no interrupt data are output to the host.
(Relevant devices: D13, D14, SM0 to 49)
User
SM53 to 63 Unused -
Address Event type
SM0
Changed from OFF to ON
Changed from ON to OFF
Changed from OFF to ON
Changed from ON to OFF
Changed from OFF to ON
Changed from ON to OFF
Changed from OFF to ON
Changed from ON to OFF
Changed from OFF to ON
Changed from ON to OFF
Interrupt code
SM1
SM2
: : :
50
H
51
H
52
H
53
H
54
H
55
H
SM48
B0
H
B1
H
SM49
B2
H
B3
H
0.5 0.5
1 1