Mitsubishi Electric FR-E700EX, Instruction Manual

Page: 161 / 323

159
Monitor display and monitor output signal
4
P
ARAME
TERS
(3) Operation panel I/O terminal monitor
(Pr.52)
 When Pr.52 is set to "55", the I/O terminal status can be monitored on the operation panel.
 The I/O terminal monitor is displayed on the third monitor.
 The LED is ON when the terminal is ON, and the LED is OFF when the terminal is OFF. The center line of LED is always
ON.
 On the unit I/O terminal monitor ( Pr.52 = "55"), the upper LEDs denote the input terminal status and the lower the output
terminal status.
(4) Cumulative power monitor and clear
(Pr.170)
 On the cumulative power monitor ( Pr.52 = "25"), the output power monitor value is added up and is updated in 100ms
increments. (The values are saved in EEPROM every hour.)
 The operation panel, parameter unit (FR-PU07) and communication (RS-485 communication, communication option)
display increments and display ranges are as indicated below.
 Writing "0" to Pr.170 clears the cumulative power monitor.
Operation Panel

Parameter Unit

Communication
Range Unit Range Unit
Range
Unit
Pr.170
= 10
Pr.170
= 9999
0 to 99.99kWh 0.01kWh 0 to 999.99kWh 0.01kWh
0 to 9999kWh
0 to 65535kWh
(initial value)
1kWh 100.0 to 999.9kWh 0.1kWh 1000.0 to 9999.9kWh 0.1kWh
1000 to 9999kWh 1kWh 10000 to 99999kWh 1kWh

Power is measured in the range 0 to 9999.99kWh, and displayed in 4 digits.
When the monitor value exceeds "99.99", a carry occurs, e.g. "100.0", so the value is displayed in 0.1kWh increments.

Power is measured in the range 0 to 99999.99kWh, and displayed in 5 digits.
When the monitor value exceeds "999.99", a carry occurs, e.g. "1000.0", so the value is displayed in 0.1kWh increments.
REMARKS
 If "0" is written to Pr.170 and Pr.170 is read again, "9999" or "10" is displayed.
RM
RL
RH
MRS STR
RES
RUN
FU ABC
STF
Center line is always ON
Input terminal
- Display example -
When signals STF, RH and
RUN are ON
Output terminal
Hz
A
V