Mitsubishi Electric FR-CC2-P, Instruction Manual

Page: 133 / 184

Copying and verifying parameters
132
PARAMETER
5.9
Copying and verifying parameters
NOTE
• When the destination is other than the FR-CC2-P series or when parameter copy is attempted after the parameter copy
reading was stopped, "model error ( )" appears.
• Refer to the parameter list on page 170 for availability of parameter copy.
• When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy writing, write again or
check the setting values by parameter verification.
• If parameters are copied from an older converter unit to a newer converter unit that has additional parameters, out-of-range
setting values may be written in some parameters. In this case, those parameters operate as if they were set to their initial
values.
5.9.1
Parameter copy
 Reading the parameter settings of the converter unit to the operation
panel
NOTE
• appears... Why?
-Parameter read error. Perform the operation from step 3 again.
Pr.CPY setting
value
Description
0.--- Initial display
1.RD Copy the source parameters to the operation panel.
2.WR
The parameters copied to the operation panel can be also copied to the destination converter
units.
3.VFY Verify parameters in the converter unit and the operation panel. (Refer to page 134 .)
• The converter unit parameter settings can be copied to other converter units.
Operation
1. Connects the operation panel to the source converter unit.
2.
Parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter number
Turn to (parameter copy), and press .
" " appears.
4.
Reading to the operation panel
Turn to change the set value to " ". Press to start reading of the converter unit parameter settings by the oper-
ation panel. (It takes about 30 seconds to read all the settings. During reading, " " blinks.)
5.
End reading
" " and " " blink alternately after settings are read.