Mitsubishi Electric FR-CC2-N Series, Instruction Manual

Page: 98 / 184

97
5. PARAMETERS
5.6 (A) Application parameters
1
2
3
4
5
6
7
8
9
10
5.6
(A) Application parameters
5.6.1 Self power management
By turning ON the magnetic contactor (MC) on the input side before the motor is started and turning OFF the MC after the motor
is stopped, power is not supplied to the main circuit, reducing the standby power.
 Connection diagram
• Sink logic, Pr.192 = "17" (input via terminals R1 and S1)
• Sink logic, Pr.192 = "17" (24V external power supply input)
Purpose Parameter to set
Refer to
page
To reduce the standby power Self power management P.A006, P.E300 Pr.30, Pr.248 97
To restart after instantaneous power
failure Automatic restart after
instantaneous power failure
P.A702 Pr.57 98
To decelerate the motor to a stop at
power failure
Power failure time
deceleration-to-stop
function
P.A730 Pr.261 99
Pr. Name
Initial
value Setting
range
Description
248
A006 Self power management
selection
0
0 Self power management function disabled
1
Self power management function enabled (main circuit OFF at protective
function activation)
2
Self power management function enabled (main circuit OFF at protective
function activation due to a circuit failure)
30
E300 Reset selection during
power supply to main circuit
0
0
When power is supplied only to the control circuit, and then switched to
be supplied to both the control and main circuits, converter reset is
performed.
100
When power is supplied only to the control circuit, and then switched to
be supplied to both the control and main circuits, converter reset is not
performed.
MC1
Converter unit Inverter
R/L1
S/L2
T/L3
R1/L11
S1/L21
U
V
W
M
(MC1)IPF
SE
24VDC
MC1
MCCB
R1/L11
S1/L21
P/+
N/-
P/+
N/-
RDA MRS(X10)
RSO RES
Y17 X94
SE SD
MC1
Converter unit Inverter
R/L1
S/L2
T/L3
R1/L11
S1/L21
U
V
W
M
(MC1)IPF
SE
24VDC
MC1
MCCB
P/+
N/-
P/+
N/-
RDA MRS(X10)
+24
SD
24VDC
+24
SD
24VDC
RSO RES
Y17 X94
SE SD