Mitsubishi Electric F930GOT-BWD-E, User Manual

Page: 57 / 274

Graphic Operation Terminal F930GOT Start up 2
2-7
2.3 Each mode selection procedure
USER SCREEN MODE
HPP MODE
TEST MODE
OTHER MODE
Production control
Number of products
Operation rate
1234
[HPP MODE] END
DEVICE MONITOR
ACTIVE STATE MONITOR
[TEST MODE] END
USER SCREEN
[OTHER MODE] END
SET TIME SWITCH
DATA TRANSFER
PC DIAGNOSIS
PRINT OUT
END [SET-UP MODE]
OTHER MODE
TEST MODE
HPP MODE
USER SCREEN MODE
[SET-UP MODE SCREEN]
• If "MAIN MENU CALL KEY" has been set in
"SET-UP MODE", when a specified touch key
is pressed, the SELECT MODE screen shown
on the left is displayed.
• The outline of each mode and the selection
procedure are described below.
• USER SCREEN MODE (Refer to
Sections 3, 8, 9, 10, 11 and 12.)
A user screen is displayed. Char-
acters such as alphabets, num-
bers, Katakana and Hiragana and
simple graphic can be displayed.
• HPP MODE (Refer to Section 4.)
Bit devices and word devices in
the PLC can be monitored.
In addition, set values of T, C and
D can be changed.
• TEST MODE (Refer to Section 5.)
The contents of the user screens
can be confir med. In addition,
d a t a f i l e s c a n b e e d it e d, a nd
debugging can be performed.
• OTHER MODE(Refer to Section 6.)
Setting of the time switch, printer
output, entry code, operation envi-
ronment, etc, can be performed.