Mitsubishi Electric DD-5000, Service Manual, Page: 26 / 76

2-8
1-3-5. Pickup Mechanism Assembly
<Removal>
1. Remove four screws (1) and four washers (2) and
then remove the pickup mechanism assembly (3).
<Mounting>
1. Replace the pickup mechanism assembly (3) with a
new one.
2. When mounting, perform the reverse order of the
removal.
Fig. 2-1-17
Note:
• The dampers’ color differs when used for the front
side and the rear.
• When mounting the pickup mechanism assembly (2)
with the screws (1), push the pickup mechanism
assembly (2) downward without being caught and
tighten the screws (1) after placing the washer with
the damper bent.
Fig. 2-1-18
1-3-6. Gear B Assembly, Gear A and Rack Gear
Assembly
<Removal>
1. Remove one screw (5) and remove the gear B assem-
bly (1).
2. Remove the gear A (2).
3. Remove one screw (3) and remove the rack gear
assembly (4).
Fig. 2-1-19
<Mounting>
1. When mounting, perform the reverse order of the
removal.
2. Mount the gear B assembly (1) by pushing the pickup
head (5) to the disc motor side (arrow A direction)
and shifting the upper gear of the rack gear assembly
(4) in the arrow B direction. (Refer to Fig. 2-1-20.)
3. Fit the positioning holes on the upper gear and lower
gear of the gear B assembly (1) and mount on the
pickup mechanism assembly with the phase matched.
At this time, note that the phase of the gear B
assembly (1) and the gear A (2) shows the status in
the Fig. 2-1-21.
Pickup mechanism
assembly (3)
Screw (1)
Washers (2)
Damper
(Black)
Damper
(Black)
Damper
(Blue)
Damper
(Blue)
Screw (3)
Rack gear
assembly (4)
Gear A (2)
Gear B assembly (1)
Pickup mechanism
assembly
Claw
Damper
Screw (1)
Washer (2)
(W6.6P0.5D12)
Pickup mechanism
assembly (3)
Screw (5)