Mitsubishi Electric CC-Link IE Field NZ2GF12A-60IOLH8, User Manual

Page: 22 / 162

20
2 SPECIFICATIONS
2.1 General Specifications
2
SPECIFICATIONS
This chapter describes the specifications of the IO-Link module.
2.1
General Specifications
*1 The product specifications are satisfied only when all of waterproof plugs and waterproof caps are installed with the recommended
connectable devices and all screws are tightened with an appropriate torque.
*2 Do not use or store the IO-Link module under pressure higher than the atmospheric pressure of altitude 0m. Doing so may cause
malfunction. When using the IO-Link module under pressure, please consult your local Mitsubishi representative.
*3 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical power
distribution network and the machinery within premises.
Category

applies to equipment for which electrical power is supplied from fixed facilities. The surge voltage withstand level for the
equipment with the rated voltage of 300V or less is 2500V.
*4 This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is used.
Pollution degree 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
To use the IO-Link module complying with the EMC Directive, refer to "EMC and Low Voltage Directives" in
this manual. (

Page 146 EMC and Low Voltage Directives)
Item Specifications
Operating ambient
temperature 0 to 55  (0 to 40  for UL listed)
Storage ambient
temperature -25 to 75 
Operating ambient
humidity Conforming to IP67
*1
Storage ambient
humidity 5 to 95%RH, non-condensing
Vibration resistance Compliant with JIS
B 3502 and IEC
61131-2 Frequency Constant
acceleration Half amplitude Number of sweeps
Under intermittent
vibration 5 to 8.4Hz  3.5mm X, Y, Z
10 times each in X,
Y, and Z directions
8.4 to 150Hz 9.8m/
 
Under continuous
vibration 5 to 8.4Hz

1.75mm

8.4 to 150Hz 4.9m/
 
Shock resistance Compliant with JIS B 3502 and IEC 61131-2 (147m/

, 3 times each in X, Y, and Z directions)
Operating atmosphere No corrosive gases
Operating altitude
*2
0 to 2000m
Installation location Inside/outside a control panel
Overvoltage category
*3

or less
Pollution degree
*4
2 or less
Equipment class Class
