48
3.5" hard disk drive
The XEN-LS II supports one 1.6" high or two 1" high, 3.5"
hard disk drives.
Preparation
To install a hard disk drive you must first remove the 3.5"
drive bay:
1.
Power the system down.
2.
If there is a diskette in the 3.5" floppy drive, remove it.
3.
Take suitable anti-static precautions and remove the
system unit cover.
If you are unfamiliar with Apricot’s recommended anti-
static precautions and/or the process of removing the
system unit cover refer to your
Owner’s Handbook.
In order to remove the 3.5" drive bay you must first remove
the 5.25" drive bay.
SECURING SCREWS
5.25" BAY
4.
If there is a drive fitted in the 5.25" bay disconnect
the power and signal cables from the rear of the
drive.
