CS380X / CS410X PREMIUM Chainsaw
17
Original Instructions Version July 16
CS380X-410X_150716
Operating the Engine
1.
Fill fuel (2) and chain oil (1) tanks respectively, and tighten the
caps securely.
2.
Set the switch (3) to “I” position.
3.
Press the primer button (4) 6 times.
4.
Pull out the choke knob (5). The choke will close and the throttle
will be set in the starting position.
5.
Push in the decompressor valve (6).
6.
Apply the chain brake (7) by pushing the chain brake forwards.
7.
Place the saw on the ground, grip the front handle with your left
hand, place your right foot through the rear handle. Pull the starter
handle with your right hand.
Caution: Do not pull the starter
cord all the way out and do not let go of the starter handle
if the cord is extended, this can damage the mechanism.
8.
When the engine has tried to fire, push in the choke knob (5) and then pull the starter
handle again to start the engine.
9.
As soon as the engine is running, pull the throttle lever slightly to reset the throttle control
to idle. This must be done as soon as the engine has started to avoid unneccessary wear
on the clutch.
NOTE: Disengage the chain brake by pulling the chain brake towards the
front handle prior to cutting.
