Mitel MIVOICE OFFICE 250, Installation And Administration Manual

Page: 384 / 585

MiVoice Office 250 Installation and Administration Guide
356
Installing an MDPM
Digital telephones equipped with PC Data Port Modules may be equipped with Modem Data Port
Modules, part number 550.3015 [PB2549-A in Europe]. The MDPM contains a four-conductor
modular jack [line jack unit] that can be used to connect a single line phone or trunk to the digital
telephone. Each “equipped” MDPM installed counts as one single line device.
For installation diagrams, see Figure 10 on
page 354
and Figure 14 on
page 357
.
To install the MDPM:
1. Ensure the phone line cord is unplugged from its modular jack on the phone.
2. Plug the free end of the PCDPM-to-MDPM interface cable into connector J1 on the MDPM. The
other end of the cable was previously attached to the PCDPM (see page 360 ).
3. Insert the phone line cord, which would normally be connected to a CO jack, into the modular
jack ( J2 ) on the MDPM.
4. Plug the main AC transformer unit into an AC power source.
Do not
use the same AC outlet
used for the equipment chassis.
5. Reconnect the phone line cord. The MDPM can be placed flat or standing on-end.
Figure 13: MDPM Cable Connection in a Mitel 8520 or 8560 Phone
PCDPM-to-MDPM
INTERFACE CABLE
(813.1566)
BOTTOM OF PHONE WITH PCDPM
(BACK)
MODEM DATA
PORT MODULE
J1
J2
(Base not shown for illustrative purposes.)
J1
J2