Slide Loft/Lie Angle Gauge Assembly to back of
machine. Place adjustable bending bar on hosel as low
as possible. Adjust bar to snug fit (finger tight) by turning
knurled knob at end of bar. See illustration 7.
To bend hosel apply light pressure to bending bar in the
direction of desired bend until it is seated firmly against
hosel. Apply short, quick jolts of bending pressure to
bend hosel. Remeasure club and rebend if necessary
to desired angles.
To adjust lie angle bend up to make more upright and
down to make flatter. The shaft should move in a plane
parallel to the front of the machine. See illustration 8.
To adjust the loft angle bend back (up) to deloft the club
and bend forward (down) to add loft to the club. The shaft
should move in a plane parallel to the side of the machine.
See illustration 9.
illustration 7
illustration 8
illustration 9
