Push the Loft/Lie Gauge Assembly to the back of the
machine to allow room to insert the club head.
Loosen the Top Worm Screw that adjusts the Top Iron
Clamp that holds the iron head in place.
Insert club head into back of Face Fixture, setting the
club sole on the two Iron Sole Clamps and the toe of
the club touching the Toe Stop. Adjust club head so the
score lines are parallel to the Horizontal Dowel Pin that
is in between the Face Fixture by adjusting the Toe Stop
inward or outward. Make sure club head is flush against
the back of the Face Fixture then tighten the Top Worm
Screw. See illustrations 1 and 2.
If necessary use the T-Wrench to tighten the Back Iron
Clamp against the back of the iron sole.
See illustration 3.
NOTE: Use the Back Iron Clamp only when the club face
does not clamp flush against the Face Fixture or when
the club head slips when bending. These conditions are
caused by the sole design on only a few models of clubs.
Do not use the Back Iron Clamp on every iron. It will slow
down your bending time and is not necessary to use on
every club.
illustration 1
illustration 2
illustration 3
