Onboard FDC Controller
This item allows you to enable or disable the on-board floppy disk drive
controller.
The available options are
Enabled
and
Disabled
. Select
Disabled
only if you
want to use a separate floppy disk drive controller card.
Onboard Serial Port 1
This item sets the I/O address and interrupt request line (IRQ) for the on-board
serial port (COM1).
The available options are
3F8/IRQ4
,
2F8/IRQ3
,
3E8/IRQ4
,
2E8/IRQ3
, and
Disabled
.
Onboard Parallel Port
This item sets the I/O address and interrupt request line (IRQ) for the on-board
parallel port (LPT1).
The available options are
378H/IRQ7
,
278H/IRQ5
,
3BC/IRQ7
, and
Disabled
.
Parallel Port Mode
This item sets the operating mode for the onboard parallel (printer) port. Your
system supports EPP (Enhanced Parallel Port) and ECP (Extended Capabilities
Port) standards which turn the standard parallel port into a high speed bi-
directional peripheral port.
The available options are
ECP+EPP1.9
,
Normal
,
EPP1.7+SPP , ECP+EPP1.7,
ECP
,
SPP, EPP1.9+SPP
and
ECP
. Select
Normal
unless you are certain your
hardware and software both support EPP or ECP mode.
ECP Mode Use DMA
This item appears only if the “Parallel Port Mode” item setting is
ECP
,
ECP+EPP1.7
, or
ECP+EPP1.9
.
The item selects a DMA channel for the parallel port for use during ECP mode.
The available options are
1
and
3
.
5-20
The SETUP Program
