4
Assembly of Pedestal
Fan
1. Before securing counter weight to both
decorative base plate and lower tube, you
must undo the cord grip on the counter
weight to position the supply cord first, as
shown in Fig.9 ( As you are unable to do this
later, as supply cord plug and connectors
cannot be fed through the cord grip when
fixed in position).
Put the nuts into the slot in rear of counter
weight, fix one screw in cord grip,position
supply cord and then fix another screw in
cord grip as shown Fig.1a & Fig.9.
Now place the counter weight within the
rim of the decorative base plate and secure
lower tube to the base plate assembly
with the retention knob by turning knob in
clockwise direction and hand tighten as
shown in Fig.1
Fig.1
Fig.1a
Note: For ease of assembly it is beneficial
at this stage of the assembly to route the
power cord with connector end through
the lower tube assembly as shown in Fig.4
and pull sufficient cable length through to
extend beyond the total length of the three
tube sections ( If electing to assemble
pedestal fan to 170cm height ), or two tube
sections (if electing to assemble pedestal
fan to height of 123 cm) as shown in Fig.10
on page 6.
2. Route the power supply cable through the
middle tube and now screw middle tube
to the lower tube in clockwise direction as
shown in Fig.2
Fig.2
3. Repeat the process for middle tube to the
upper tube as shown in Fig.3
Note: The upper tube is identifiable by the
presence of the two holes, differentiating it
from the middle tube.
Fig.3
4. Allow for enough of the power cord and
connector to protrude through the upper
tube so that connection can be made with
the connector extending from the fan head.
Fig.4
