6
Step 6: Fitting misting plate to front
safety grille.
Unscrew and remove the 4 retaining screws from
the mist plate assembly.
Position the mist plate onto the front safety grille
and secure it to the safety grille with 4 screws and
tighten. (see Fig. 6)
Fig. 6
Step 7: Fitting front safety grille/mist
plate assembly to the rear safety
grille.
Unhinge the grille retaining clips from around the
front safety grille parameter.
Clip the retaining bracket over the rear grille and
hinge the retaining clips to the closed position to
capture the rim of the rear safety grille with the
hinge clips until all closed.
Finally secure grille into place with the safety
screw and nut on the bottom of grille assembly.
(See Fig.7)
Fig.7
Step 8: Fitting water tank to the cart
Fix water tank on the cart-shelf with nominated
screws and nuts (Fig8)
a. Tip fan assembly slowly backwards to lay on
the floor to gain access to the screw holes on
the bottom of the cart tank shelf.
b. Secure the tank to the cart-shelf with 4 x M8
washers and M8 x 10mm screws and tighten
them with a spanner.
c. Position the fan assembly upright.
Note: If you do not use mist fan for a
long time, please unscrew the drain
hole at the bottom of the water
tank,and when the water is drained,
tighten it again.
Operation
1. After assembly this misting fan, before
connect to power supply, need remove the
protection red wires from the grilles;
2. Open water tank cover, pour enough clean
water into tank then cover it;
3. Connect power supply, turn on fan switch
first(this switch is underneath the protection
cover), then turn on pump switch, the misting
volume could be adjusted according to the
misting volume indication.
4. Three speed for the fan setting, 0 for off, 1 for
Low, 2 for Medium and 3 for High.
