3
11/30/15 REV.A
4
3
2
1
4
4
Weight
here
Weight
here
5
2
1
6
Screw quick connector to the free end of hose.
Align block (1) and tabs on quick connect. Push quick connect housing
firmly upward and snap onto receiving block. Pull down moderately to
ensure connection has been made.
If it is necessary to remove quick connect, squeeze tabs on hose
between index finger and thumb, then pull down to disconnect.
Install the weight clip (2) at the point of the hose (3) marking “weight
here”. Insert the weight (4) onto the clip (2) by sliding it down onto the
clip (2).
Making the waterline connections
Thread the nut (1) on supply line onto outlet of water supply valve (2)
and tighten with wrench. Do not overtighten.
After installation is complete, remove the sprayer by unscrewing it in a
counter-clockwise direction.
Turn on the water supply to flush debris from the faucet. Run the hot and
cold water for at least one minute each.
Important: This flushes away any debris that could cause damage to
internal parts.
